Custom bifold closet doors – Bifold doors are ideal for close, closet-like areas where there is not enough space for swing doors. They are decorative, usually with some variety of louvered wood panels and fit into an array of kitchen cabinet and situations. Bifold doors come as a kit, and installation is simple, requiring only a few hand tools.
So that the doors open. Center header track, an assembly slide and closed at the upper edge of the door or cabinet. If the custom bifold closet doors kit contains a separate track for each door line-up tracks so that just and your starter holes they pencil. Take the track screws into the holes of the starter to the tracks to the top of the entrance to secure.
Tightening the pivot mount 1/4-inch from both ends of the custom bifold closet doors frame with a Phillips screwdriver. The pivot brackets contain a hole for a Peg, activate the doors to swing open and closed while. In the header track Attach the string of the plumb line to the upper pivots, so the weight hangs an inch above the ground. Cut away the carpet in the form of wood cut with a utility knife. To put pieces of wood into it and secure the block with a wood screw.
Tap. On the nylon guide pins into the holes at the upper corners of the doors these pins fit into the pivot mount in the Slider track. Use gently taps the hammer. Tap next, the adjustable pivots in the bottom of the doors. Mark a place on the edge of the doors, where they meet, to install the doorknobs. Choose from a height that is comfortable. Install the knobs of the rear of the doors to hide the screw. Drill a whole starter and then screw the knob fasteners. All screws on the doorknob at the door.